4door L.E.D Kit

• 5 Colours 2 Switches L.E.D Lighting Kit
• Blue, Red, Green, Purlple, Aqua Colours Included

Installation Instructions: (please read disclaimer below)

This kit comes with 4 L.E.D Pads. 2 to be mounted under the back of the front set and 2 to be mounted under the front dash.
Run the harness under the centre console feeding the 2 longest harnesses towards the rear of the front seats and pull one of the harnesses out towards the rear of the driver’s seat and the other toward the rear of the passenger seat. N.B must allow for back and forward movement of both front seats and harness to avoid damage to harnesses when adjusting seat position.

Peel off layer from double sided tape and stick the 2 pads to underneath the rear of each seat. Run the 2 rocker switches to where you want them mounted (either into centre dash or use the removable dash inserts to mount switches), drill two 8 mm holes, unscrew the top nuts and poke the 2 switches out of hole coming in from underneath. Tighten the top nuts to secure switches.

Now pull out the 2 front harnesses 1 to be mounted underneath the dash on the driver’s side (at bottom of the driver’s side dash to shine on foot pedals) and the other to be mounted underneath the dash on the passenger side (at bottom of glove box or bottom of dash as to shin down on passenger floor). The double sided tape is used to stick the four pads to their mounted positions.

The red wife is fused and should be wired with solder and tape to accessory wire in fuse box or ignition switch. White wire should be mounted to chassis or earth circuit.

Disclaimer: To power up the kit we fully recommend going to your local auto electrician. No warranty on damaged items if not fitted by a fully qualified automotive electrician and we take no responsibility for damages occurred whilst fitting.